Lexington
(859) 422-1900
Louisville
(502) 961- 6100
Cincinnati
(513) 632- 6500
HOME
PRODUCTS
MANUFACTURERS
SPECIALS
ABOUT US
CREDIT APPLICATION
LOCATIONS
CONTACT US
BROWSE CATEGORIES
> Bolt
> Nail
> Nut
> Screws
> Staple
> Washer
Abrasives
Access Doors | Vents | Roof Access
Adhesives | Sealants | Tape
Diamond Products
Drill Bits and Drilling Accessories
Electrical Products and Equipment
Electronics | Batteries
Equipment
Fasteners | Anchors
Fastening Pins & Inserts
Hand Tools
Ladders | Platforms | Scaffolding
Leveling | Measuring | Surveying
Lighting Supplies
Paints | Equipment | Supplies
Power Tool Accessories
Power Tools
Rental Equipment
Safety Equipment and Products
Saw Blades
Shop Vacuums
Sports Drinks and Thirst Quenchers
Strut, Channel, & Fittings
Tool Storage | Job Site Boxes | Truck Boxes | Transfer Tanks
Home
/
Categories
/
> Bolt
/
Specialty Bolts
/
Search:
Tension Loads for STHD Installations:
Simpson Strong-Tie
(click image to enlarge)
SKU / Product Info
Quantity
LSTHD8
Strap Length: 18-5/8" Rim Joist: 32-1/8" le: 8" Req'd Nails 20-16d Sinkers Non Cracked Midwall: 3115 Corner: 2700 Endwall: 1690 Cracked Midwall: 2675 Corner: 2320 Endwall: 1455
Quick Overview
Use all specified fasteners. See General Notes.
Install before concrete pour with a StrapMate, or other holding device.
Nail strap from the bottom up.
Strap may be bent one full cycle (bent horizontal 90° then bent vertical) to aid wall placement, but may cause spalling behind the strap. If the spall is 1" or less, measured from the embedment line to the bottom of the spall, full loads apply. 1" to 4" spalls for LSTHD8 achieve 0.9 times table loads. STHD10 and STHD14 achieve full load for spalls less than 4". Any portion of the strap left exposed should be protected against corrosion.
Other than where noted in the two-pour detail, do not install where:
(a) a horizontal cold joint exists within the embedment depth between the slab and foundation wall or footing beneath, unless provisions are made to transfer the load, or the slab is designed to resist the load imposed by the anchor; or
(b) slabs are poured over concrete block foundation walls.
Additional studs attached to the shearwall studs or post may be required by the Designer for wall sheathing nailing.
Wood shrinkage after strap installation across horizontal members may cause strap to buckle outward.
Interested in this item or want more information?
Call Mon. through Fri. 7:30 AM - 4:00 PM EST
Phone: (859) 422-1900
Email:
online@jiffyfastening.com
Can't find what you want? Give us a call and we can help you find it.
Details
The STHD is an embedded strap-tie holdown offering high load capacity and a staggered nail pattern to help minimize splitting. The STHD incorporates many features that aid correct installation and improve performance. When installed on the forms with the StrapMate® strap holder the unique design of the STHD delivers enhanced stability before and during the pour to help prevent both parallel and perpendicular movement (relative to the form). This results in accurate positioning of the strap and reduced possibility of spalling.
Additional Information
Manufacturer: Simpson Strong-Tie
Search:
© 2013- Jiffy Fastening Systems | All Rights Reserved
Powered by 48ws.com